Fed's Kashkari tells NYT it is 'way too soon' to cut rates

Kitco Media
By Reuters
Published:
Updated:
Reuters
Fed's Kashkari tells NYT it is 'way too soon' to cut rates teaser image

Jan 14 (Reuters) - Minneapolis Federal Reserve President Neel Kashkari did not want to cut interest rates last month ​and sees no need to cut them any time soon ‌given labor market resilience and inflation above the Fed's target, the New York Times reported on Wednesday.

"I don't see any impetus to cut in January," Kashkari was quoted as saying in an interview with the newspaper, ‌adding that it was "way too soon" for a rate ​cut, which could be possible later this year.

Kashkari told the New York times he took some comfort that lawmakers from both political parties ‍have expressed support for an independent Fed and for Fed Chair Jerome Powell.

The Trump administration has subpoenaed Powell over remarks he made to Congress last summer ⁠in a move the Fed Chair said was an attempt to ‍intimidate the central bank into cutting rates.

The Fed is widely expected to leave the ‌policy ‌rate in its current 3.50%-3.75% range when it meets in two weeks, after cutting it by 75 basis points in 2025, including a quarter-of-a-percentage point reduction approved by a 9-3 vote at its December ⁠meeting.

Kashkari, who has ⁠a vote on ​the rate-setting panel this year, indicated he could support a rate cut later this year if the unemployment rate, at 4.4% in December, jumps, especially if ‍inflation also eases.

But for now, he said, inflation that has run above the Fed's 2% target for years and could stay there for another two or three ​years is "very concerning," the newspaper reported.

A ‍government report on Tuesday showed consumer prices rose 2.7% last month from a year earlier.

Reporting ​by Nilutpal Timsina in Bengaluru. Editing by Mark Potter and Alexander Smith

Disclaimer: The views expressed in this article are those of the author and may not reflect those of Kitco Metals Inc. The author has made every effort to ensure accuracy of information provided; however, neither Kitco Metals Inc. nor the author can guarantee such accuracy. This article is strictly for informational purposes only. It is not a solicitation to make any exchange in commodities, securities or other financial instruments. Kitco Metals Inc. and the author of this article do not accept culpability for losses and/ or damages arising from the use of this publication.